有机酸性腐蚀品生产危险性分析

目前我国化工生产中涉及大量有机酸性腐蚀品,通过对某市化工行业调查及分析,发现有机酸性腐蚀品生产普遍,而且生产原料易燃易爆,生产过程存在火灾爆炸危险,结合具体生产工艺,采用预先危险性分析法和作业条件的危险性评价法分析生产过程危险性,从而揭示并概括有机酸性腐蚀品生产危险性.为更好地促进我国安全生产,在此基础上探讨了一些针对性的安全措施.     

Modeled Summer Background Concentration of Nutrients and Suspended Sediment in the Mid‐Continent (USA) Great Rivers1

Angradi, Ted R., David W. Bolgrien, Matt A. Starry, and Brian H. Hill, 2012. Modeled Summer Background Concentration of Nutrients and Suspended Sediment in the Mid‐Continent (USA) Great Rivers. Journal of the American Water Resources Association (JAWRA) 48(5): 1054‐1070. DOI: 10.1111/j.1752‐1688.2012.00669.x Abstract: We used regression models to predict summer background concentration of total nitrogen (N), total phosphorus (P), and total suspended solids (TSS), in the mid‐continent great rivers: the Upper Mississippi, the Lower Missouri, and the Ohio. From multiple linear regressions of water quality indicators with land use and other stressor variables, we determined the concentration of the indicators when the predictor variables were all set to zero — the y‐intercept. Except for total P on the Upper Mississippi River, we could predict background concentration using regression models. Predicted background concentration of total N was about the same on the Upper Mississippi and Lower Missouri Rivers (430 μg l^?1), which was lower than percentile‐based values, but was similar to concentrations derived from the response of sestonic chlorophyll a to great river total N concentration. Background concentration of total P on the Lower Missouri (65 μg l^?1) was also lower than published and percentile‐based concentrations. Background TSS concentration was higher on the Lower Missouri (40 mg l^?1) than the other rivers. Background TSS concentration on the Upper Mississippi (16 mg l^?1) was below a threshold (30 mg l^?1) designed to protect aquatic vegetation. Our model‐predicted concentrations for the great rivers are an attempt to estimate background concentrations for water quality indicators independent from thresholds based on percentiles or derived from stressor‐response relationships.     

毛木耳产漆酶发酵条件的研究

以毛木耳为产酶菌，以CMC为唯一碳源，探讨了不同培养条件对毛木耳产漆酶的影响。结果表明，在最适温度为27℃、pH值为6．0、接种量为10％、装液量为90mL／250mL、摇床转速为180rpm、培养天数为6d时，产酶活力最大。以各个因子的最佳梯度做优化培养，发酵液中的漆酶活力高达70．76IU／mL。     

影响原油生物降解因素的实验研究

以原油为唯一碳源,从长期被石油污染土壤中筛选出6株原油降解菌SY1~SY6,通过单因素实验研究初始pH、温度、充氧量(摇床转数)、盐浓度、氮源和磷源等环境因素和营养条件对各菌株生物降解原油的影响。实验结果表明:6株原油降解菌在初始pH7~9,温度30℃,摇床转速180 r/min时生长良好,且能有效地降解石油类污染物,其平均降解率为50%以上。6菌株在盐浓度在1%时生长良好,SY3菌和SY4菌能在盐浓度10%以上生长,具有一定的耐盐能力。同时,6菌株以氯化铵(NH4Cl)为氮源,磷酸氢二钾(K2HPO4)和磷酸二氢钾(KH2PO4)的混合物(2∶1)为磷源时生长良好,因此可作为各菌生长的最适氮源和磷源。研究结果可以为含油废水的处理提供微生物基础。     

A strategy for aromatic hydrocarbon bioremediation under anaerobic conditions and the impacts of ethanol: a microcosm study

Increased use of ethanol-blended gasoline (gasohol) and its potential release into the subsurface have spurred interest in studying the biodegradation of and interactions between ethanol and gasoline components such as benzene, toluene, ethylbenzene and xylene isomers (BTEX) in groundwater plumes. The preferred substrate status and the high biological oxygen demand (BOD) posed by ethanol and its biodegradation products suggests that anaerobic electron acceptors (EAs) will be required to support in situ bioremediation of BTEX. To develop a strategy for aromatic hydrocarbon bioremediation and to understand the impacts of ethanol on BTEX biodegradation under strictly anaerobic conditions, a microcosm experiment was conducted using pristine aquifer sand and groundwater obtained from Canadian Forces Base Borden, Canada. The initial electron accepter pool included nitrate, sulfate and/or ferric iron. The microcosms typically contained 400 g of sediment, 600 approximately 800 ml of groundwater, and with differing EAs added, and were run under anaerobic conditions. Ethanol was added to some at concentrations of 500 and 5000 mg/L. Trends for biodegradation of aromatic hydrocarbons for the Borden aquifer material were first developed in the absence of ethanol, The results showed that indigenous microorganisms could degrade all aromatic hydrocarbons (BTEX and trimethylbenzene isomers-TMB) under nitrate- and ferric iron-combined conditions, but not under sulfate-reducing conditions. Toluene, ethylbenzene and m/p-xylene were biodegraded under denitrifying conditions. However, the persistence of benzene indicated that enhancing denitrification alone was insufficient. Both benzene and o-xylene biodegraded significantly under iron-reducing conditions, but only after denitrification had removed other aromatics. For the trimethylbenzene isomers, 1,3,5-TMB biodegradation was found under denitrifying and then iron-reducing conditions. Biodegradation of 1,2,3-TMB or 1,2,4-TMB was slower under iron-reducing conditions. This study suggests that addition of excess ferric iron combined with limited nitrate has promise for in situ bioremediation of BTEX and TMB in the Borden aquifer and possibly for other sites contaminated by hydrocarbons. This study is the first to report 1,2,3-TMB biodegradation under strictly anaerobic condition. With the addition of 500 mg/L ethanol but without EA addition, ethanol and its main intermediate, acetate, were quickly biodegraded within 41 d with methane as a major product. Ethanol initially present at 5000 mg/L without EA addition declined slowly with the persistence of unidentified volatile fatty acids, likely propionate and butyrate, but less methane. In contrast, all ethanol disappeared with repeated additions of either nitrate or ferric iron, but acetate and unidentified intermediates persisted under iron-enhanced conditions. With the addition of 500 mg/L ethanol and nitrate, only minor toluene biodegradation was observed under denitrifying conditions and only after ethanol and acetate were utilized. The higher ethanol concentration (5000 mg/L) essentially shut down BTEX biodegradation likely due to high EA demand provided by ethanol and its intermediates. The negative findings for anaerobic BTEX biodegradation in the presence of ethanol and/or its biodegradation products are in contrast to recent research reported by Da Silva et al. [Da Silva, M.L.B., Ruiz-Aguilar, G.M.L., Alvarez, P.J.J., 2005. Enhanced anaerobic biodegradation of BTEX-ethanol mixtures in aquifer columns amended with sulfate, chelated ferric iron or nitrate. Biodegradation. 16, 105-114]. Our results suggest that the apparent conservation of high residual labile carbon as biodegradation products such as acetate makes natural attenuation of aromatics less effective, and makes subsequent addition of EAs to promote in situ BTEX biodegradation problematic.     

北京夏季典型PM2.5与O3相继重污染事件分析

根据北京市环境保护监测中心发布的PM2.5和O3小时质量浓度及气象、卫星遥感数据,分析了2013年7月2日至10日北京典型PM2.5及O3重污染过程的质量浓度特征及在大气边界层过程各个阶段的质量浓度演变.结果表明,北京夏季O3质量浓度先于PM2.5达到峰值,而天气型演变是导致这一现象的主要原因.具体过程为:1)重污染初始阶段,高压天气型利于前体物积累,PM2.5及O3质量浓度升高;2)在反气旋中部,由于各种污染物质量浓度较低,对大气紫外波段辐射的吸收较弱,导致该阶段紫外辐射强,因而加快了O3生成的光化学反应,O3质量浓度最先达到峰值;3)在反气旋后部,随PM2.5质量浓度增加,辐射变弱,因此O3质量浓度增加速度下降,而受高压后部影响,区域内PM2.5经东南风输送通道进入北京,导致北京PM2.5质量浓度相继达到峰值;4)在重污染清除阶段,在北方反气旋前部的冷锋清除作用下,PM2.5及O3质量浓度同时降低至谷值.     

高寒条件下振弦式传感器在线测量尾矿坝浸润线的误差分析及对策

为减少和消除高寒条件下振弦式传感器在线测量浸润线的误差,通过理论分析和现场试验,对造成误差的因素及其影响情况进行了深入研究。结果表明,振弦式传感器产生测量误差的主要来源为设备安装深度的测量误差与尾矿水密度及重力加速度的取值误差,并提出了减少或消除误差的方法和工程技术措施,为高寒地区的浸润线在线精确测量提供了重要指导意义。     

基于二值逻辑的复合绝缘子状态判别策略研究

复合绝缘子是架空输电线路上广泛使用的设备,它的老化会给电力系统的正常运行带来威胁。电力相关工作人员需要一种能够对复合绝缘子的运行状态进行判别的方法,帮助他们确定复合绝缘子是否满足运行要求,而对复合绝缘子的定性表征就成为一种优选的表征策略。将运行后的复合绝缘子分成"满足运行要求"和"不满足运行要求",使用二值逻辑回归模型,选取合适的特征量,建立了复合绝缘子状态表征体系。     

二氧化碳灭火系统扑灭风电机组舱内火灾试验研究

为有效遏制全国多地风力发电机组火灾事故的势头,基于灭火系统在风电机组防火设计中的重要性,提出采用二氧化碳灭火系统对风电机舱进行灭火保护的解决方案。在建造国内首台风电机组火灾模拟试验装置的基础上,通过试验研究二氧化碳灭火系统在常温状态和低温状态下对风电机组火灾的灭火能力。结果表明,该灭火系统能够对风力发电机组进行全淹没灭火保护,适用于空间狭小且结构复杂的风电机舱;在低温条件下,其喷放时间和灭火时间虽比常温状态下长,但灭火效能并未降低。     

An easy method to design gas/vapor relief system with rupture disk

Tank discharge gas/vapor flow problems are frequently encountered in both practice and design. To perform this type of design calculation, the first step is to identify whether the flow is choked or not through a trial-and-error solution of an equation for adiabatic flow with friction from a reservoir through a pipe. Developing a direct method without any trial-and-error to identify a choking condition would be helpful for expediting the flow calculations. This paper presents an easy and quick method to identify the choking of gas flow for an emergency relief system consisting of a rupture disk and vent piping. This greatly simplifies the design calculations. The proposed method for validating the venting adequacy of existing ERS circumvents the iteration calculation and the use of Lapple charts. Three case studies for the design of vent piping for rupture disks support the proposed method.